[CNMO Technology News] AMDs Ryzen 7 9800X3D processor as the strongest game CPU in the market has attracted much attention once it was launched.However, recently the processor has been exposed to burning on the AM5 motherboard slot for the first time, causing the CPU and motherboard slot to be completely damaged.
It is reported that a Reddit user "Trumppoopoospants" posted a photo of his AMD Ryzen 7 9800X3D processor on the Internet, saying it was equippedMSI MAG X870 Tomahawk motherboard.However, the user said that the computer could not start and displayed the "00" error code.After inspection, he found that multiple metal contact points on the CPU and AM5 slot were burned.It is worth mentioning that another user on the MSI forum also reports a similar "00" error code, but it is not sure whether there is a similar burning situation.
This burning incident caused widespread discussion. Some analysts believe that it may be the motherboard problem, which causes excessive voltage to enter the CPU through metal contact points.Then cause burning.It is worth noting that AMDs earlier Ryzen 7 7800X3D processor also had a similar burning accident on the ASUS X670 motherboard. At that time, it was due to the high SOC track voltage, and then the problem was solved through BIOS update.
However, some Reddit users pointed out that the CPU pin in the accident looked a little bent, and the side of the slot seemed to be damaged. It may be that the user made a mistake during installation.Although this possibility has not been confirmed, if it is not installed, other users who buy Ryzen 7 9800X3D do not have to worry too much about the design defects in the CPU itself.
It is worth mentioning that the AMD processor design has a single direction insertion method, which is usually difficult to make mistakes during installation.In addition, when AMD processors are burned, it usually forms obvious protrusions under the metal contact point, but this does not occur in the accident.This also shows that this burning accident may be a case and is not universal.
To avoid similar situations, AMD recommends that users must carefully check whether the contact points and pins of the motherboard and CPU before installing the CPU are intact without damage.EssenceEven if a slight pins are bent or position deviation, it will cause irreversible damage to PC hardware.
